Normal Operation; Device Start-Up; Configuration - Vimar PIXEL UP 40415 Manuel De L'utilisateur

PIXEL UP: 40415
4. Notification messages
The following screen appears in the device start-
up phase and the user must wait for the start-up
phase to complete. Wait for the phase to complete.
If other messages persist, contact the installer.
5. Indicators
The device has LEDs used specifically for signalling, in the top left-hand corner.
Icon
5.1

Normal operation

Status
Call in progress
Communication active
Lock activated
Missed communication (user busy or offline)
Video message recording in progress
5.2

Device start-up

Status
A - Switch-on
B – Secondary module detection
C – Secondary module firmware updating in progress
D1 – Device awaiting configuration
D2 – Device configured but not operational
D3 – Device operational
Times: 0.25 s ON, 0.75 s OFF.
1
Times: 1.00 s ON, 0.75 s OFF.
2
6.

Configuration

Refer to the installer manual.
Loading...
Starting
LED Colour
L1 Red
L2 Green
L3 Green
LED
L3 flashing
L3 ON
L2 ON
L1 ON
L3 ON, L1 flashing
LED L3
ON
OFF
OFF Flashing
Flashing Flashing
1
Flashing Flashing
2
OFF
EN
LED L2 LED L1
ON ON
OFF Flashing
Flashing
1
Flashing
1
Flashing
2
OFF OFF
1
1
1
2
17