Menuett 004271 Mode D'emploi page 19

temperature is 200°C and the standard
setting for time is 0 minutes.
5. Press the FUNCTION button again.
The status light TIMER goes on and
timer mode is activated. The time can
be set from 0 to 180 minutes with the
buttons "+" and "-". The timer starts
automatically after 5 seconds.
6. Pressing FUNCTION again, the TIMER
indicator will light up, the cooker will
enter the state of Setting Time. Time Can
be adjusted by "+" or "-" from 0-180
minutes. Five seconds later, the timer will
automatically start.
7. An audio prompt is given 30 seconds
before the product switches off
automatically.
8. Press the touch-button LOCK when the
required function has been selected to
lock the setting. The lock status light goes
on and the product does not respond to
touch. To reset or switch off the product,
press the touch-button LOCK until 2 beeps
are given. All the touch-buttons can now
be used as normal.
FIG. 2
WARNING!
The product gets hot when in use.
PANS THAT CAN BE USED
Use pans intended for an induction hob, with a
base diameter of 12–26 cm.
PANS THAT CANNOT BE USED
• Do not use pans made of copper,
aluminium, ceramic or heat-resistant
glass, or pans with round bottoms, feet or
a bottom diameter less than 12 cm.
• If the pan is made of a material that is not
compatible with an induction hob the
error code EO will be shown.
USING THE TOUCH-BUTTONS
See diagram showing how to use the touch-
buttons.
FIG. 3
MAINTENANCE
• Pull out the plug from the power point
and wait until the product has cooled.
• Clean the product after it has been used.
• Dirty pans can cause discolouring or burn
marks on the product surface.
• Wipe the product with a cloth moistened
with a mild detergent. Do not use hard or
abrasive utensils or detergents.
• Clean the ventilation openings on the
product with a vacuum cleaner.
• Do not rinse or pour water on the product.
The penetration of water can cause the
electronic components to stop working.
EN
19