Electrolux EXO18HEIWE Manuel D'installation page 15

5
Out-let pipe sheath (Optional)
6
Out-let pipe Clasp (Optional)
7
Drain joint
8
Installation paper board (Optional)
9
Soundproof / insulation sheath (Optional)
Seal ring (Optional)
10
11 Expansible hook (Optional)
12 Installation hook (Optional)
Orice (Optional)
13
Frame (Optional)
14
15 Mounting screw (ST2.9X10-C-H)(Optional)
Note: Other necessary parts for the installation, besides the above mentioned, must be pro-
vided by the customer/installer.
3.3 Before installation
1. Decide the correct carry-in path.
2. According to the instructions, move
this unit as originally packaged as
possible.
3.
If the air conditioner is installed on a
metal part of the building, it must be
electrically insulated according to the
relevant electrical code.
4. If installing in a lonely building or at
a high position where it is hot and
humid with frequent thunderstorm,
lightning-protection equipment is
necessary.
5. Neccessary room
Fig.11
Outlet
Inlet Outlet
Ground
Fig.12
>1000
3.4 Indoor unit installation
Install the main body
The existing ceiling (to be horizontal)
1. Please cut a quadrangular hole of
600 X 600mm in the ceiling according
to the shape of the installation paper
board. (Refer to Fig.13 & 14 for
product dimension)
• The center of the hole should be at
the same position of that of the air
conditioner body.
• Determine the lengths and outlets of
ENGLISH 15
1
1
1
1
1
1
4
4
1
1
2
>1000