Garland BEAR 804 VE-V20 Manuel De L'utilisateur page 36

English
Attention! While transporting the machine or the
machine is tilted, do not use it.
1. Press the pressure lever (left) to lower the blade
and hold the log.
2. Keeping the pressure lever (left) depressed, lower
the cutter lever (right) to cut. You can adjust the
cutting speed by lowering the cutter lever (right)
more or less. Adjusting the cutting speed with the
cutter lever (right):
3. Press the reverse lever (center) to return the blade
to its initial position.
Elephant:
Slow speed
Rabbit:
Fast speed
36/156
Attention! Before using the
machine, purge the air from
the hydraulic system.
1. Loosen the cap 1/2 to
1 turn
2. The air flow must be
detectable during
operation.
3. Before moving the
machine make sure that
the lid is tightly closed to
avoid leaks.
Use extensions for the feeding
cable with a minimum section
Ø 2,5 mm
of 2,5 mm2.
2
Dispose of your appliance organically.
Do not throw in it in domestic trash
containers.
Comply with the CE directives (EU
standards).