Repair Parts - Chamberlain LiftMaster KPW5 Mode D'emploi

BATTERY
To prevent possible SERIOUS INJURY or DEATH:
• NEVER allow small children near batteries.
• If battery is swallowed, immediately notify doctor.
To reduce risk of fire, explosion or chemical burn:
• Replace ONLY with 9V Lithium battery.
• DO NOT recharge, disassemble, heat above 212° F (100° C) or incinerate.
The 9V Lithium battery should produce power for up to
5 years. To replace the battery:
1. Unlock and remove the faceplate from the mounting
plate.
2. Remove the battery cover using a Phillips screw
driver.
3. Remove the old battery and install new 9V Lithium
battery. Re-install inner cover.
4. Reattach the faceplate to the mounting plate and
lock with the key.
5. Dispose of old battery properly.

REPAIR PARTS

PART NUMBER
K093A0763
K107A0031
TROUBLESHOOTING
SYMPTOM
The keypad will not
program to the operator.
The backlight and tone on
the keypad no longer work.
Key press turns on
backlight but no beep.
PIN won't learn.
PIN won't learn.
ONE YEAR LIMITED WARRANTY
LiftMaster warrants to the first consumer purchaser of this product that it is free from defect in materials and/
or workmanship for a period of 1 year from the date of purchase.
NOTICE: To comply with FCC and or Industry Canada rules (IC), adjustment or modifications of this receiver and/or transmitter are
prohibited, except for changing the code setting or replacing the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.
Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including interference that
may cause undesired operation.
CAUSE
The keypad is programmed to the
wrong frequency and encryption.
Battery may be dead.
Stuck button.
PIN already learned.
Memory full.
LiftMaster.com
1-800-528-2806
Mounting plate
DESCRIPTION
Mounting Plate
Keys
SOLUTION
Program the keypad to match the operator's
frequency and encryption (see page 3).
Replace battery with 9V Lithium battery.
Check that all buttons are not stuck.
Learn a new PIN. Exit Learn.
Erase a PIN to add a new pin. Perform
Factory Reset to erase all PINs.
Battery Cover
Faceplate
Battery