Basic Programming - Chamberlain LiftMaster KPW5 Mode D'emploi

BASIC PROGRAMMING

The Wireless Commercial Keypad must be put into programming mode prior to any of the programming steps
below unless otherwise indicated. The keypad backlight will remain on if the product is in programming mode.
While in programming mode, if an invalid code is entered, an error tone will sound, but the keypad will remain
in programming mode. After 60 seconds of inactivity, the keypad will exit the programming mode. The 6-digit
Master Code is used to prevent unauthorized access to the system. A Master Code is required (factory default
code: 888888) to operate the Wireless Commercial Keypad. It is highly recommended to change and record
your unique Master Code.
Set Master Code
Programming Step
1. Enter program mode
2. Update Master Code 09 # (New 6-digit Code) # (New 6-digit Code)
3. Exit Program Mode
Program a PIN
Programming Step
1. Enter program mode
2. Set new pin
3. Exit Program Mode
NOTE: An error tone will sound if the maximum number of PINs is exceeded or if user tries to program a PIN
already programmed in the memory.
PROGRAM TO OPERATOR
Program to LiftMaster Operator
NOTE: The Master Code and a PIN need to be set before the gate operator can be programmed. See Basic
Programming.
KPW5 - The frequency and encryption are set at the factory. Proceed to Step 4.
KPW250 - The frequency and encryption are set at the factory for LiftMaster Security+ 2.0 (tri-band 310,
315, and 390 MHz) operators. Proceed to Step 4.
For LiftMaster Security+ (315 MHz or 390 MHz), the frequency and encryption need to be set.
Proceed to Step 1.
1. Enter program mode:
2 Set frequency and encryption (KPW250 only):
• LiftMaster Security+ 315 MHz - Press 03 # 2 #. A long tone will sound.
• LiftMaster Security+ 390 MHz - Press 03 # 3 #. A long tone will sound.
• To reset factory default - Press 03 # 1 #. A long tone will sound.
3. Exit Program Mode:
4. Press the Learn Button on the operator.
5. Within 30 seconds - Enter a valid 4-digit PIN then press #. A long tone will sound.
Keystroke Combination
(Master Code) #
*
#
#
* *
Keystroke Combination
(Master Code) #
*
01 # (New 4-digit PIN) # Repeat (new 4-digit
PIN) #
#
* *
(Master Code) #
*
#.
* *
3
Indicator
Long tone
Long tone
Keypad backlight will turn off
Indicator
Long tone
Long tone
Keypad backlight will turn off