Chamberlain LiftMaster KPW5 Mode D'emploi page 4

PROGRAM TO OPERATOR
Program to Linear Multi-Code Receiver
KPW250 ONLY
1. Locate the DIP switch sequence on the operator and record it. If DIP switch is in the "up" or "on"
(CLOSED)position place a 1, "down" or "off" (OPEN) position place a 0 in the corresponding box in the
chart below.
DIP Switch Sequence
UP / ON (CLOSED)
DOWN / OFF (OPEN)
NOTE: Leave any unused switch locations blank.
Write the DIP switch 10-digit sequence: ___ ___ ___ ___ ___ ___ ___ ___ ___ ___
2. Enter program mode:
3. Set Linear Multi-Code frequency and encryption: Press 03 # 4 #. A long tone will sound.
4. Enter the DIP Switch sequence (Use ONLY 1 and 0). Press #. A long tone will sound.
5. Exit Program Mode:
6. Press the Learn Button on the operator.
7. Within 30 seconds - Enter a valid 4-digit PIN then press #. A long tone will sound.
NOTE: When entering the DIP Switch sequence 3 beeps will sound if an incorrect number of entries is input.
Once an operator has been programmed, enter a valid 4-digit PIN and the # key to activate the operator.
ADDITIONAL PROGRAMMING
The Wireless Commercial Keypad must be put into programming mode prior to any of the programming steps
below unless otherwise indicated.
Set Temporary PIN
A temporary 4-digit PIN can be programmed to allow access to visitors (maximum of 9 uses). The temporary
PIN cannot be the same as any previously programmed PIN. The keypad will store up to 10 unique temporary
PINs.
Programming Step
1. Enter program mode
2. Set Temporary PIN
3. Exit Program Mode
Delete Permanent and Temporary PIN
Programming Step
1. Enter program mode
2. Delete PIN
3. Exit Program Mode
1 2
(Master Code) #. A long tone will sound.
*
#.
* *
Keystroke Combination
(Master Code) #
*
05 # (New temporary 4-digit PIN) # (New tempo-
rary 4-digit PIN) # Number of uses (9 maximum) #
#
* *
Keystroke Combination
(Master Code) #
*
07 # (4-digit PIN to be deleted) # (4-digit PIN to
be deleted) #
#
* *
3 4 5 6
4
7 8 9 10
Indicator
Long tone
Long tone
Keypad backlight will turn off
Indicator
Long tone
Long tone
Keypad backlight will turn off