Before Use; Safety Instructions - Briteq COB Blinder 2x100W Mode D'emploi

ENGLISH
OPERATION MANUAL
Thank you for buying this BRITEQ
safety, please read these operating instructions very carefully before you start using this unit.
FEATURES
This unit is radio-interference suppressed. This product meets the requirements of the current European and
national guidelines. Conformity has been established and the relevant statements and documents have been
deposited by the manufacturer.
• LED BLINDER equipped with two white 100Watt "COB" LED-projectors
• Both projectors can be independently controlled
• Different operation modes:
o DMX control: 3modes, 1ch, 2ch or 4ch
o Static mode: dim + strobe
o Master/slave mode
• Variable Strobe (can be used as LED Strobe!)
• The lamp behavior can be continuously adjusted from led to halogen.
• Four dimmer curves: linear, square, inverse square, S-curve
• In case of DMX failure you can choose between blackout and freeze mode.
• Lock function to avoid unwanted altering of the settings.
• Dimming from 0% to 100%
• Beam angle: 60°
• Color temperature: 3200K
• Note: this device was designed to produce effect lighting and is used as blinder in light shows, this
projector is not designed for long-term use as lighting fixture.

BEFORE USE

• Before you start using this unit, please check if there's no transportation damage. Should there be any, do
not use the device and consult your dealer first.
• Important: This device left our factory in perfect condition and well packaged. It is absolutely necessary
for the user to strictly follow the safety instructions and warnings in this user manual. Any damage caused
by mishandling is not subject to warranty. The dealer will not accept responsibility for any resulting defects
or problems caused by disregarding this user manual.
• Keep this booklet in a safe place for future consultation. If you sell the fixture, be sure to add this user
manual.
Check the contents:
Check that the packing contains the following items:
• Operating instructions
• COB BLINDER 2X100W
• Neutrik Powercon mains cable

SAFETY INSTRUCTIONS:

The lightning flash with arrowhead symbol within the equilateral triangle is intended to alert the
use or the presence of un-insulated "dangerous voltage" within the product's enclosure that may
be of sufficient magnitude to constitute a risk of electric shock.
BRITEQ
®
®
product. To take full advantage of all possibilities and for your own
CAUTION: To reduce the risk of electric shock, do not remove
the top cover. No user-serviceable parts inside. Refer servicing
to qualified service personnel only.
1/44
USER MANUAL
COB BLINDER 2X100W