Briteq COB Blinder 2x100W Mode D'emploi page 9

ENGLISH
The firmware of this unit can be upgraded using a special upgrade tool with Windows
available from Briteq).
Each time the projector is switched on, the display shows "UPDATE Wait ....": while this message shows on
the display you can start the update using our special upgrade tool. More information about this can be found
in the user manual of the upgrade tool and / or our website: www.briteq-lighting.com
OPERATING INSTRUCTIONS
IMPORTANT: This projector is an effect projector (Blinder). It is NOT supposed to be used
CONTINUOUSLY at full power like a normal projector.
A. Standalone 1unit:
• Just connect the projector to the mains.
• Set the intensity of both outputs + the flashrate for your standalone mode.
• Refer to chapter HOW TO SETUP to learn how to make the previous settings.
B. Two or more units in master/slave setup:
• Connect the units together. Refer to the chapter "electrical installation" to learn how to do this.
• Set the intensity of both outputs + the flashrate on the master (the first projector in the DMX chain)
• Set all the other projectors in SLAVE mode.
• The projectors will now follow the program of the master projector so they all work synchronously.
C. Controlled by universal DMX-controller:
• Connect all units together. Refer to the chapter "Electrical installation for two or more units in DMX-
mode" to learn how to do this (don't forget to address all units properly!)
• Connect all units to the mains and turn on the DMX controller.
Since each unit has its own DMX-address, you can control them individually. Remember that each unit
uses 1, 2 or 4 DMX-channels, depending on the DMX-mode you have selected in the menu. See the
different DMX charts below:
DMX Chart for the 1 channel DMX-Mode
DMX Chart for the 2 channel DMX-Mode
DMX Chart for the 4 channel DMX-Mode
BRITEQ
®
Channel 1 Dimmer
000-255 0-100%
Channel 1 Dimmer
000-255 0-100%
Channel 2 Strobe
000-255 Flash speed
Channel 1 Dimmer left side
000-255 0-100%
Channel 2 Dimmer right side
000-255 0-100%
Channel 3 Strobe
000-255 Flash speed
Channel 4 Dimmer curve
000-015 dimmer curve selected on the fixture itself
016-135 Linear dimmer
136-255 Square dimmer
7/44
USER MANUAL
®
software. (separately
COB BLINDER 2X100W