On-Board Tool Cleaning; How To Replace The Vacuum Belt - Tornado CK-14/1 Pro Manuel D'utilisation Et De Pièces

This vacuum is equipped with on-board cleaning tools including a
metal telescopic wand, stretch hose, dusting brush and crevice tool.
1. To use the cleaning tools, lift the hose handle straight up from
the vacuum.
2. Extend the wand by pushing the button forward and pulling the
smaller wand out of the larger wand
3. Attach any of the on-board tools to the end of the wand or if you
do not need the wand, any tool can be connected directly onto
the hose handle.
CAUTION: Unplug the vacuum cleaner before
performing any of these steps.
How to Remove the Bottom Plate
1. Place the vacuum cleaner in the low position (see page 7).
Turn the vacuum over.
2. Slide the clips toward each other (Fig. 18).
3. Remove the bottom plate.
How to Replace the Belt
1. Turn the unit over and remove the bottom plate as described in
the above section.
2. Lift the belt cover and turn toward the outside (Fig. 19 & 20).
3. Remove the agitator by pulling it straight out.
4. Remove the belt from the agitator and motor pulley.
5. Loop a new belt over the motor pulley and over the end of the agitator.
6. Stretch the belt over the agitator while inserting it back into the brush head
housing.
7. Turn the belt cover back over the motor pulley. Make sure cover
releases down into the brush head.
8. Replace the bottom plate by hooking the front end of the plate into the
two ribs on the front end of the brush head housing. (Fig. 21)
Press the bottom plate into place by sliding the clips away from each other.
NOTE: To ensure maximum cleaning efficiency, check the belt regularly to
ensure it is in good condition. Replace the belt if it is stretched, cracked or
if excessive slipping is occurring.
All manuals and user guides at all-guides.com

On-Board Tool Cleaning

How to Replace the Vacuum Belt

Fig. 18
Fig. 19
Fig. 20
Fig. 21
8
Fig.17
Fig 17