Preparing For Use; Operation; Starting The Machine; Using The Machine - Tornado Marathon 350 Manuel D'instructions

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Preparing for Use

Make sure both tanks are clean before use.
Connect the flexible vacuum hose onto the vacuum hose inlet and the high-pressure spray hose
onto the solution outlet. (fig. 1)
Connect the vacuum hose and the high-pressure spray hose to the carpet cleaning wand or the
upholstery tool.
Fill the clean water tank with detergent and water. Use the correct dilution rate for the detergent.
Never over fill.
Fill the anti-foam tank with an appropriate de-foamer solution.
Important – Always use low foaming carpet cleaning chemicals. If using foaming carpet cleaning chemical, or if foam develops
due to residues in the carpet, ensure that an appropriate de-foamer is used in the anti-foam tank.
Incorrect chemicals could cause damage to the carpets being cleaned or cause the machine to malfunction.

Operation

Starting the Machine

Connect the cable to main power.
Ensure the slider on top of the trigger unit is in the closed position
Switch on the unit spray and/or vacuum.
Squeeze the trigger to spray solution onto the carpet/upholstery. Maintain a constant pressure of
the wand/tool onto the surface to be cleaned. (fig. 2)

Using the Machine

To dry the surface being cleaned, complete the cleaning with a second pass with the vacuum (and no spray).
Never soak the textile being cleaned while spraying.

Cleaning Carpet

Color Fastness – Before using cleaning solution or pre-spotter, test carpet for color fastness on an inconspicuous area. Apply solution
to a small piece of clean white material or tissue, and then rub on carpet vigorously. Excessive amounts of dye showing on the
material indicate that the color is not fast, and the carpet should not be wet cleaned.
Move furniture around to give a clear working area. Cover bottoms of furniture legs where necessary (aluminum cooking foil is
ideal). Pin up curtains and drapes.
Vacuum carpet thoroughly to remove any residual dust or debris.
Areas of heavy carpet soiling can be removed more easily if first treated with a concentrated cleaning solution or pre-spotting
solution.
Rate of cleaning will depend upon the thickness of the carpet and the degree of dirt in the area being cleaned.
Do not clean any more than twice. Carpets may shrink if they are over-wet or not properly fixed down.

Cleaning Stairs

CAUTION – When cleaning on stairs take great care to ensure that machine is stable, otherwise it may cause injury to either the
operator or a third party. Use the stair/upholstery tool for cleaning in place of the wand assembly.
7

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

98132

Table des Matières