303 Parameter Table - Unity I UT3K Manuel D'utilisation

b. Press [
E
now change parameters that require a user password. For password requirements, see the third column
N
of the parameter table in Section 303.
G
L
Note:
I
S
3. Press [
CANCEL
H
switch between the parameter number and parameter value.
4. Use the [%
to display the parameter value.
5. Whenever a parameter value is displayed, use these keys to change the setting:
• Press [%
• Press [
Note: In step 1, you entered the user password. If a parameter requires a higher password for changes,
the UPS will not let you change that parameter.
6. To enter the new value, press [
If you wish not to save a change that you have made, press [
original setting.
7. If you wish to change additional parameters, repeat steps 3-6.
8. To escape parameter mode, press [
Table 3 explains what each of the keys does when a parameter number or parameter value is displayed.
Table 3: Parameter Mode Key Functions
Key
CANCEL
VOUT
%LOAD
VLINE
RUNTIME

303 Parameter Table

The parameter table, Table 4, explains many of the unit's parameters. See Sections 301 and 302 for
information on displaying and changing parameters.
Note: Some parameters are not listed. These parameters are used only in special circumstances or are
intended to help qualified service personnel troubleshoot, adjust, and calibrate the UPS.
] to enter the password. The display should read I (for password level 1). You may
RUNTIME
If no keys are pressed for five minutes, the UPS password level goes back to level "0," and
you must re-enter the user password.
] to return to the parameter number display (P-XX). Note that the [
] or the [ ] key to go to the parameter that you wish to change. Then press [
LOAD VOUT
] to increase the setting.
LOAD
] to decrease the setting.
VOUT
RUNTIME
Programming When a Parameter
Template Key Name Number is Displayed
# Switches to the parameter
value.
— Goes back to the previous
parameter number.
+ Goes to the next parameter
number.
ESC Escapes parameter mode.
5 This key has no function
when the parameter number
is displayed.
]. The UPS beeps to confirm that the new value has been entered.
] twice.
VLINE
14
CANCEL
] and the value will remain at its
VLINE
When a Parameter Value is Displayed
Switches to the parameter number.
Decreases the parameter setting.
Increases the parameter setting.
Returns to the parameter number display without
saving any changes made to the parameter value.
Enters the new parameter setting.
] key lets you
]
CANCEL