Metabo HPT N 1804DA Manuel D'instructions Et De Sécurité page 23

● For intermittent operation, Set the stapling
operation switch to FULL SEQUENTIAL
ACTUATION MECHANISM (Stapling operation
indicator is light in blue.) (i.e. Set to SINGLE
ACTUATION MECHANISM.)
● To avoid double fi ring or accidental fi ring due
to recoil.
1) Set to FULL SEQUENTIAL ACTUATION
MECHANISM.
2) Pull the trigger rapidly and fi rmly.
Set the stapling operation switch to FULL
SEQUENTIAL
(Stapling operation indicator is light in blue.)
Position the staple outlet on the workpiece with
fi nger off the trigger.
Depress the push lever fi rmly until it is completely
depressed.
Pull the trigger to drive a staple.
Remove fi nger from the trigger and lift the tool off
the wood surface completely.
To continue stapling in a separate location, move the
stapler along the wood, repeating steps
required.
NOTE
Operations and
4 seconds of each other. If more than 4 seconds
pass after , the Stapler will not work properly. If this
happens, retry from
Stapling operation switch
Push lever
WARNING
ACTUATION MECHANISM
–
should be done within
.
Stapling operation
indicator (Light in blue)
Trigger
(2) Continuous operation (Push lever fi re)
Using CONTACT ACTUATION MECHANISM
● To avoid double fi ring or accidental fi ring due
to recoil.
1) Do not press the stapler against the wood
with excessive force.
2) Separate the stapler from the wood as it
recoils after stapling.
Set the stapling operation switch to CONTACT
ACTUATION MECHANISM (Stapling operation
indicator is blink in blue.)
Pull the trigger with the Stapler off the workpiece.
Depress the push lever against the workpiece to drive
a staple.
Move the Stapler along the workpiece with a
bouncing motion.
Each depression of the push lever will drive a staple.
As soon as the desired number of staples have been
driven, remove fi nger from the trigger.
NOTE
as
Operations
2 seconds of each other. If more than 2 seconds pass
after , the Stapler will not work properly. If this
happens, retry from
Stapling operation switch
English
WARNING
and should be done within
.
Stapling operation
indicator (blink in blue)
Previously pull the trigger
23