Loading Staples - Metabo HPT N 1804DA Manuel D'instructions Et De Sécurité

(8) Set the stapling operation indicator blinking ON
mode. (CONTACT ACTUATION MECHANISM)
Push the stapling operation switch once, make sure
that the indicator is blinking Blue.
Blink in blue
Separate the push lever from the workpiece, pull the
trigger.
Depress the push lever against the workpiece within
2 seconds.
□ THE STAPLER MUST OPERATE.
(9) If no abnormal operation is observed, you may load
staples in the Stapler.
Drive staples into the workpiece that is the same type
to be used in the actual application.
□ THE STAPLER MUST OPERATE PROPERLY.

LOADING STAPLES

● When loading staples into Stapler,
1) remove battery from the stapler;
2) do not pull trigger;
3) do not depress push lever; and
4) keep stapler pointed downward.
(1) Pull the staple feeder backward, and confi rm that
the feeder stopper is securely lodged in the feeder
stopper hole on the staple feeder.
Staple feeder
WARNING
Feeder stopper
(2) Place the staple strip over the magazine.
Make sure that the staple strip slides freely on the
magazine.
Staple
(3) Pull the staple feeder backward slightly, and press in
the feeder stopper. Push the staple feeder forward.
Gently set the staple feeder to the back of the loaded
staples.
The Stapler is now ready to operate.
CAUTION
If the staple feeder is released all of a sudden, it
can return abruptly, causing deformation and/or
scatter, eventually ending up in clogged staples.
Be absolutely sure to bring back the staple
feeder, avoiding any impact.
English
Magazine
Feeder stopper
Staple feeder
21