Husky HDS500 Instructions D'utilisation page 7

Operating Instructions
troubleshooting Chart (Continued)
Stop using tool immediately if any of the following problems occur. Serious personal injury
could occur. Any repairs or replacements must be done by a Qualified Service Person or
Authorized Service Center.
Symptom
Will not spray
No pressure in tank
notes
possible Cause(s)
1. No pressure at gun
2. Fluid control not open enough
3. Fluid too heavy
4. Fluid pressure too low (pressure feed)
1. Regulator damaged or defective
2. Check valve stuck
Corrective action
1. Check air lines
2. Open fluid control
3. Thin fluid or change to pressure feed system
4. Increase fluid pressure
1. Replace regulator
2. Clean or replace check valve
7
HDS500, HDS750