Sony DSBK-200 Manuel D'installation page 13

2
Connect the flat cable connector to the connector on the
bottom of the remote control panel, then remove the screw
for grounding and tighten it together with the ground wire.
Fix the flat cable connector in place by fastening the
retaining clips at each end of the connector on the remote
control panel.
Retaining clips
Note
Make sure that the projection on the underside of the
connector matches the cutout on the control panel
connector. The connector cannot be inserted upside down.
Connector on the bottom of
the remote control panel
Flat cable connector
Ground wire
Screw for grounding
(Continued)
13