Important Safety Instructions; Applicance Handling Safety; Safety Codes And Standards; Electric Safety - Thermador MASTERPIECE Serie Instructions D'installation

IMPORTANT SAFETY INSTRUCTIONS

9
READ AND SAVE THESE INSTRUCTIONS
T T E F V E A S A S T N D A N T A R D O P A E M R I
WARNING
If the information in this manual is not followed exactly,
fire or shock may result causing property damage or
personal injury.
WARNING
Do not repair or replace any part of the appliance unless
specifically recommended in the manuals. Improper
installation, service or maintenance can cause injury or
property damage. Refer to this manual for guidance. All
other servicing should be done by a qualified technician.

Applicance Handling Safety

Do not lift applicance by door handle. Remove the door
for easier handling and installation. See instructions in
Use and Care Manual.
Unit is heavy and requires at least two people or proper
equipment to move.
Hidden surfaces may have sharp edges. Use caution
when reaching behind or under appliance.

Safety Codes and Standards

This appliance complies with one or more of the
following Standards:
UL 858, The Standards for the Safety of Household
▯
Electric Ranges
UL 923, The Standards for the Safety of Microwave
▯
Cooking Appliances
UL 507, The Standard for the Safety of Electric Fans
▯
ANSI Z21.1, The American National Standard for
▯
Household Cooking Gas Appliances
CAN/CSA-C22.2 No. 113-M1984 Fans and Ventilators
▯
CAN/CSA-C22.2 No. 61-M89 Household Cooking
▯
Ranges
It is the responsibility of the owner and the installer to
determine if additional requirements and/or standards
apply to specific installations.

Electric Safety

Before you plug in an electrical cord, be sure all controls
are in the OFF position.
If required by the National Electrical Code (or Canadian
Electrical Code), this appliance must be installed on a
separate branch circuit.
Installer - show the owner the location of the circuit
breaker or fuse. Mark it for easy reference.
Important - save these instructions for the local electrical
inspector's use..
Before installing, turn power OFF at the service panel.
Lock service panel to prevent power from being turned
ON accidentally.
Refer to data plate for more information. See "Data
Plate" under "Service" for data plate location.
Be sure your appliance is properly installed and
grounded by a qualified technician. Installation, electrical
connections and grounding must comply with all
applicable codes.

Related Equipment Safety

Remove all tape and packaging before using the
appliance. Destroy the packaging after unpacking the
appliance. Never allow children to play with packaging
material
Never modify or alter the construction of the appliance.
For example, do not remove leveling legs, panels, wire
covers or anti-tip brackets/screws.

Transport

To avoid damage to the oven vent, use the transport
method shown in the picture below.
5