Videotec GEKO IRN Manuel D'instructions page 6

The white light LED illuminator emits
high-intensity visible light. In compliance
with standard EN62471/IEC62471, the
photobiological safety assessment has
classified the device in Risk Group 2, where
it exceeds the values of the Exempt Group.
The risk linked to the observer depends
on how the product has been installed
and is used. For installation, follow the
instructions in this manual. Do not open
the illuminator for whatever reason. Do not
look directly at the illuminator using optical
lenses. Exposure hazard values (EHV):
20.8s. Hazard distance (HD): 200mm.
RISK GROUP 2
CAUTION: Possibly
hazardous optical radiation
emitted from this product.
Do not stare at operating
lamp. May be harmful to
the eye.
Fig. 2 White light illuminator.
During normal operation the surface of the
illuminator can reach high temperatures.
Do not allow direct contact and position
the appliance where it is inaccessible to
unauthorised persons. Before touching
switch off the illuminator and allow to cool
for a minimum period of 10 minutes.
• The manufacturer declines all responsibility
for any damage caused by an improper use
of the appliances mentioned in this manual.
Furthermore, the manufacturer reserves the right
to modify its contents without any prior notice.
The documentation contained in this manual has
been collected with great care, the manufacturer,
however, cannot take any liability for its use. The
same thing can be said for any person or company
involved in the creation and production of this
manual.
4
GROUPE DE RISQUE 2
ATTENTION: Des
rayonnements optiques
dangereux peuvent être émis
par ce produit. Ne pas regarder
la lampe directement. Peut
être dangereux pour les yeux.
CAUTION! The device must be installed
only and exclusively by qualified technical
personnel.
• Before starting any operation, make sure the
power supply is disconnected.
• Do not use cables that seem worn or old.
• Never, under any circumstances, make any
changes or connections that are not shown in
this handbook. Improper use of the appliance
can cause serious hazards, risking the safety of
personnel and of the installation.
• Use only original spare parts. Non-original spare
parts could cause fire, electrical discharge or other
hazards.
• Before proceeding with installation check the
supplied material to make sure it corresponds
to the order specification by examining the
identification labels (4.2 Product markings, page 5).
• A disconnecting device, readily and easily
accessible, must be incorporated in the electrical
system of the building for rapid intervention.
• To connect the power supply line use the
appropriate junction-box (IRNJBUL). For further
information, refer to the product use and
installation manual.
MNVCIRN_1420_EN