Use Instructions - Fellow Corvo EKG Manuel D'instructions

• Do not operate in the presence of explosive and/or flammable fumes.
• Do not use for other than intended use. This appliance is intended for household and commercial
use only. Use for anything other than intended use will void the one-year warranty.
• TO PREVENT SCALDING:
-Never use the kettle without its lid.
-Do not remove the lid while the kettle is boiling.
-Scalding may occur if the lid is removed during the brewing cycles.
-Be aware of steam being emitted from spout or lid especially during refilling.
-Water can remain hot for a long time after boiling and can present a scalding hazard. Keep
the kettle and the kettle base away from the edge of the work surface and out of the reach of
children. Do not remove the lid until the kettle cools down.
• GROUNDED PLUG: This appliance has a grounded, three-prong plug and must be grounded with a
three-prong outlet when in use. To ensure protection against risk of electric shock or fire, connect
to properly grounded outlets only. Do not attempt to defeat this safety feature.
• DO NOT HEAT AN EMPTY KETTLE: The concealed heating element in the bottom of the kettle is
protected by an automatic safety device. If your kettle is accidentally heated without being filled or is
allowed to boil dry, it will automatically cool down and then turn off. If this happens, unplug the kettle,
fill with cold water, and wait a few minutes before replacing it on the base and plugging in.
• Save these instructions.

Use Instructions

Please read all use instructions fully before turning on and using your kettle.
First Time Use Cleaning
• Place the Corvo EKG's base and kettle on a flat, level surface.
• Remove Corvo EKG's lid to add water. Do not remove lid if hot.
• After adding water, insert lid and ensure spout is not close to and/or facing a wall or cabinet.
• Plug the power cord into wall outlet - make sure to follow the safety guidelines above.
• For FIRST USE, rinse interior of kettle and then boil small amount of water (approx halfway full from
the "max fill" line in diagram 1C). Make sure you fill to at least the min fill point in diagram 1C.
• Set goal temperature to 212 degrees Fahrenheit or 100 degrees Celsius to boil cleaning water.
• Boil water for one minute, then turn off kettle.
• Discard initially boiled water; this water should not be consumed. Your Corvo EKG is now ready
to use.
5