Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4. REMOVE FILTERS AND GREASE DRIP RAIL
A. Remove tape on filters.
Remove filters from hood and set
aside.
NOTE: It is recommended to start
with the center one(s).
B. Remove tape on grease drip rail (1).
Lift out grease drip rail and set
aside.
5. REMOVE THE ADAPTER
S
INGLE BLOWER HOOD
Remove both screws retaining the adapter/damper (1) from inner top of
the hood.
D
OUBLE BLOWER HOOD
First unplug both blower motors (1) before removing 3 screws retaining
the adapter (2) from inner top of the hood.
NOTE: The double blower hood adapter is sent unfold. See beside.
Fold the adapter and insert the male part (grey section shown in inset)
into the female part (white section shown in the inset). Then, fold over
each male and female end to finalize assembling the adapter.
A
HD0240
(INTERNAL BLOWER HOODS ONLY)
- 8 -
1
B
1
HD0259
1
HD0339
HD0284
2
Publicité
Table des Matières
