Connecting The Mouse Receiver; Using The Mouse; Installing The Batteries - Targus PAWM002E Mode D'emploi

NOTE: the third button and the scrolling wheel only
work with the operating systems listed above. if you
use the mouse with a different operating system, it
will lose its enhanced features and function as a
standard, two-button mouse.

Connecting the Mouse Receiver

To connect the mouse receiver:
1 Plug the USB receiver into an available USB port on
your computer.
2 Follow any on-screen instructions to complete the
native operating system driver installation.
You are now ready to install the supplied batteries, and
set the radio frequency (RF) link between the mouse and
its receiver.

Using the Mouse

Installing the Batteries

1 If the mouse is on, slide the on/off switch on the bottom
of the mouse to the "off" position.
2 Remove the battery cover from the top of the mouse by
pressing the battery cover hinge located on the bottom
of the mouse and sliding it off.
NOTE: the battery cover is also the top cover of the
mouse.
3 Insert the supplied batteries, making sure that the
positive (+) and negative (-) ends of each battery match
the polarity indicators inside the battery housing.
Targus optical wireless notebook mouse
8