Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Fig 6.1
Connection of plug and socket
1
2
„ cl i c k "
1
3
2
3
30°
10
Cooper Crouse-Hinds GmbH
6.1
6.1
6.1
Connection / disconnection
Connection / disconnection
Connection / disconnection
6.1
6.1
Connection / disconnection
Connection / disconnection
of plug and socket
of plug and socket
of plug and socket
of plug and socket
of plug and socket
The flange sockets and inlets shall
only be operated with the
associated, undamaged plugs and
couplers.
Attention shall be paid that the
coding (time setting) of the plugs
and sockets is the same.
Connecting plug and socket
1. Insert the plug or inlet with the guide lug in
the correct position into the respective
keyway of the coupler or flange socket.
2.
1. Insert until 1 stop is reached.
2. Turn plug or inlet through ca. 30° in
relation to the coupler or flange socket until
the stop is reached.
3. Join plug and socket completely.
2
3. Press the coupling nut of the plug on and
1
screw it tight.
The IP degree of protection and the
mechanical connection are established by
tightening the coupling nut.
Disconnecting plug and socket
1. To disconnect plug and socket, carry out
the above actions in the reverse order.
When opened, the live plug and
socket system components shall be
sealed immediately after disconnection
using the protective cap.
The explosion protection is no
longer guaranteed if the plug and socket
components are not inserted correctly.
After a short circuit, the plug and
socket systems shall be checked to
ensure that they function correctly. As,
after several short circuits, the
flameproof encapsulation of the plug
pins and contacts sockets is no longer
guaranteed, the complete plug and
socket system (flange socket/plug or
coupler/plug or inlet/coupler) shall be
replaced.
Publicité
Table des Matières
