Continuous Mode Set-Up - Royal Sovereign RDH-230 Manuel Du Propriétaire

CONTINUOUS MODE SET-UP

GARDEN HOSE INSTALLATION
Water can be automatically emptied by attaching a hose to the continuous drainage port on the back of the
dehumidifier. This will allow the unit to run continuously (depending on the selected humidity level) without
having to empty the water bucket. To drain, simply attach a standard garden hose
NOTE: The thread standard for garden hoses in the US and its territories is known as GHT or "garden hose
thread" which has an outer diameter of 11/16 inches(1.0625 inches or 27.0 mm) and a pitch of 11.5 TPI.
Place dehumidifier on a level surface.
•
• Unscrew the cap on the back of the unit to access the garden hose nozzle
• Thread a garden hose
Make sure that there are no kinks or knots in the garden hose.
• Turn on the unit and press the "MODE" button until set to Continuous Mode.
CONTINUOUS DRAINING USING THE PUMP (270P ONLY)
The patented heavy-duty pump system allows water removal of up to 13 ft. (3.9m.) in height. If you
want the water to flow directly to a drain, connect the condensation discharge tube supplied to the
connection pipe located on the lower front part of the unit. Select the dehumidifying function and press
the "PUMP" button.
NOTE: With the condensation discharge hose missing and the pump switched ON, the display will show
the "Pump" Indicator light blinking. To eliminate this problem:
• Check the hose is correctly positioned.
• Disconnect and reconnect the plug.
onto the accessible nozzle, lead to a floor drain, and cut to length.
(not included)
.
(not included)
11