Set-Up - Royal Sovereign BDH-450 Manuel Du Propriétaire

set-uP

autO-PumP system
1. Put the hose clamp over the end of the auto-pump drainage hose by squeezing the 2
tabs of the clamp together, this will open the clamp to slide onto the hose.
2. Push the drainage hose over the auto-pump drainage outlet.
3. Push the hose clamp over the outlet to secure the hose.
4. Put the draining end of the hose over any suitable area where water can be emptied:
a sink, drain or window. Be sure the water flows away from the building or any other
objects that could be damaged.
note: The draining hose must not be put more than 10 feet above the floor on which the
unit is standing.
1.
manual DraininG
1. Take out the rubber stopper on the manual drain hose outlet.
2. Position the manual drain outlet directly above a floor drain if possible. If not, use a 1/2-inch diameter hose to drain into a place lower than the unit.
Installing 1/2-inch diameter hose:
If there is a steel or plastic tip on you 1/2-inch diameter hose, it should be removed.
1. Put a 11/16-inch diameter hose clamp over the hose
2. Then, push the hose over the manual drain outlet.
3. Push the clamp over the outlet to secure the hose
4. Put the draining end of the hose over a drain or suitable place for water to empty.
note: Manual drain hose and 11/16-inch hose clamp not included.
2.
3.
1.
4.
A B
1. 2.
6
2.
3.
C
4.
3.
4.
A