Gemini CDMP-7000 Mode D'emploi page 14

c u e c o n t r o l s
SeTTing H oT cUeS
During playback or in pause mode, press HOT CUE
1, 2 or 3 (10) at the point in the track where the
HOT CUE is to be set.
Once pressed, the programmed HOT CUE (1, 2, or
3) should now be illuiminated.
To delete a hot cue, press MEMO (9) to enable de-
leting and select the hot cue for deletion.
PLAYin g HoT cUeS
Before playing hot cues, make sure MEMO (9) is not
enabled.
During playback or in the pause mode, press HOT CUE 1,
2 or 3 (10) and playback starts instantaneously from the
point recorded on that HOT CUE.
-
c d m p 7 0 0 0 m a n u a l • g e m i n i d j
c o n t i n u e d
.
c o m
p l a y b a c k c o n t r o l s
l o o p c o n t r o l s
Pictured LOOP IN / LOOP OUT/ADJUST / RELOOP/EXIT (8)
S eTTi n g A Lo oP
During playback, press LOOP IN (8) at the
desired starting position for the loop (loop in
point).
Press LOOP OUT / ADJUST (8) at the desired
ending position for the loop (loop out position).
The loop out point is now set and loop playback
starts from the loop in point.
A djU STin g A LooP
To adjust the loop once the loop is set, press the
OUT/ADJUST (8) button. The LOOP IN (8) button
will stop blinking.
• The length of the loop can be adjusted by rotat-
ing the jogwheel (30) clockwise to extend the loop.
Rotate the jogwheel counterclockwise to shorten the
loop.
c An ce Lin g A LooP
While the loop is engaged, press RELOOP/EXIT
(8) to disengage the loop. Playback continues
after the loop out point.
R e TUR n in g To A Lo oP
After canceling a set loop, press RELOOP/EXIT
(8) during playback to reengage the last set loop.
Loop playback begins at the loop in point.
14