Hilti HIT-HY 150 MAX 1400 Jumbo Mode D'emploi page 10

Hilti HIT-HY 150 MAX / 1400 Jumbo
 Apply designed load/torque after "t cure" has passed, and the fixture to be attached has been posi-
tioned. See table 12.
Partly used foil packs must be used up within one week. Leave the mixer attached to the foil pack manifold in
the dispenser and do not retract the pistons! Remove the air pressure hose and store under the recommended
storage conditions. If reused, attach a new mixer and discard the initial quantity of anchor adhesive as descri-
bed by point 8.
Hilti accepts no liability for damage or failure caused by:
– Storage and transport not in accordance with the specified conditions.
– Failure to observe the instructions for use and the setting data.
– Inadequate design of the anchor points (number of anchors, loadbearing capacity / dimensions).
– Inadequate loadbearing capacity of the base material.
– Incorrect use.
– Other influences of which Hilti is not aware or on which Hilti has no influence, e.g. use with
products from third party.
10
Printed: 04.12.2018 | Doc-Nr: PUB / 5206054 / 000 / 03