Signal Turn On / Off; Volume Pre-Selection Of Sound Signal - OHAUS Frontier FC5714 Manuel D'instructions

Frontier TM Centrifuge FC5714/FC5718/FC5718R/FC5816/FC5816R/FC5916/FC5916R
the word "CELSI" flashes and you can change the display into Fahrenheit "FAREN", with the adjusting knob (1)
(See figure 31).
After you have stored the settings (See 4.1.1) you change back to the normal program mode again by switching off
the centrifuge for a short while.
4
5

4.1.3 Signal turn on / off

Proceed as described under point 4.1.1 to enter this program mode and then press the key "Accel/Decel" (5). In
the display "Acc/Dec" (A-2) the word "Service" flashes. Now select the letter "L" with the adjusting knob (1). As a
result, the words "On Sound" appears in the display "RPM | RCF" (4). If you press the key "RPM | RCF" (4) now,
the word "On" flashes and you can switch off the sound with the adjusting knob (1) (See figure 32).
After you have stored the settings (See 4.1.1) you change back to the normal program mode again by switching off
the centrifuge for a short while.
A-1
4
5

4.1.4 Volume pre-selection of sound signal

Proceed as described under point 4.1.1to enter this program mode and then press the key "Accel/Decel" (5). In
the display "Acc/Dec" (A-2) the word "Service" flashes. Now select the letter "U" with the adjusting knob (1). As a
result, in the display "RPM | RCF" (A-1) the words "Vol=0- 9/Sound" appear. After pressing the key "RPM | RCF"
(4), you can adjust the desired volume between 0 (low) and 9 (loud) with the adjusting knob (1) (See figure 33).
After you have stored the settings (see 4.1.1) you can change back to the normal program mode again by
switching off the centrifuge for a short period.
A-1
4
5
Figure. 31
A-2
Figure. 32
A-2
Figure. 33
EN-15
1
1
1
1