NSK PTL-CL-LED Manuel D'instructions page 4

( 2 ) Disconnecting
1 ) To disconnect, pull back the connector ring and gently pull out.
2 ) Losen the hose nut and gently pull out the hose.
CAUTION
Ensure the handpiece is attached tightly and properly to the coupling. Do not pull the
connector ring during air pressure supply. If the connector ring pulled during air
pressure supply, handpiece may fly away.
4
3. Controlling Water Supply ( PTL-CL-LED III, KCL-LED,SCL-LED )
Water supply is controlled by turning the Water Adjustment Ring.
PTL-CL-LED III Water Adjustment Ring can rotate both sides. Flooding decreases when it turns
to back side or front side start to mark keep the mark. When the Water Adjustment Ring is
turned 180 degree, water supply stop. ( Refer to Fig.4 PTL-CL-LED III )
KCL-LED,SCL-LED Water Adjustment Ring can rotate back side to decrese the water
supply. ( Refer to Fig.4 KCL-LED,SCL-LED )
PTL-CL-LED III KCL-LED
Decrease
Decrease
SCL-LED
Decrease Decrease
Fig. 4
5