Whirlpool W84TE 72 X AQUA Mode D'emploi page 14

The Water Dispenser (If available)
Mounting the Water Tank
Place the water tank in the plastic holder on the door, pitched in the direction of the arrow
on the diagram.
After you have mounted the water tank, push it down to firmly secure it in the holder.
Add your drinks with the help of the water tank top cover.
Release the side locking covers to detach the water tank cover.
To serve your drinks, gently press the valve lever.
Filling the Water Tank
• Remove the top cover of the water tank.
• Fill the tank up with water.
• Mount the top cover back on the water tank.
Important: Do not use the water dispenser for anything except water.
Important: If you leave water in the tank for a long time, it will cause an odour. In this case, clean the
tank and keep using it.
Important: Clean the water tank before using it for the first time.
Cleaning the Water Tank
• Lift the water tank.
• Remove the tank cover by releasing the side locking covers.
• Clean the tank with warm water and reassemble the pieces that you have removed.
Stowing the Water Tank
• Install the water tank as shown.
• Make sure that the tap and the hole match each other while installing.
• Water flow may not be as expected if the tank has not been installed properly. Also check that the
gaskets have been assembled properly.
Drip Tray
Please pay attention in order not to go down min level on the tank surface. During the usage of
dispenser the water can be splash after min water level.
Please hold the glass momentarily after distribution to avoid drips.
EN - 14