Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation of Battery
The first use of remote control, remote control to activate the
battery piece remove protection! It is located at the bottom
back side of the remote control.
Replace remote control battery
1. Loosen the screw on the battery compartment cover
with a screwdriver. Pull out the battery compartment
with your fingernails.
2. Replace a new battery (size CR2025) correctly and fully
insert the battery compartment back to the original
position.Tighten the screw with a screwdriver.
Handling the Remote Control
➢ Remove the batteries if the remote control is not going to be used for an extended period of
time.
➢ To avoid possible failure, read the following instructions and handle the remote control
properly.
➢ Do not drop or cause impact to the remote control.
➢ Do not spill water or any liquid on the remote control.
➢ Do not place the remote control on a wet object.
➢ Do not place the remote control under the direct sunlight or near sources of excessive heat.
➢ Do not use caustic cleaners (porcelain, stainless steel, toilet, or oven cleaner etc. ) on the
remote, as it may suffer damage.
Note:
Remove the battery from remote control handset when it is not to be used for a long period.
Otherwise it can be damaged due to leakage of battery.
Point the remote control to the unit no more than 6 meters
from the remote control sensor and within 60° horizontally and
40° vertically of the front of the unit. The operating distance
may vary according to the brightness of the room.
Note:
➢ Make sure that there is no obstacle between the infrared
remote sensor of the unit and
remote control. If you install the unit on rack, etc.., the
remote controllable range may decrease depending on
the thickness or color of glass door of rack.
➢ Do not expose the infrared remote sensor to direct sunlight or other strong light, such as in
verter fluorescent light.
DAB1000 / English Instruction Manual
6
Publicité
Chapitres
Table des Matières
