JVC KD-R890BT Manuel D'instructions page 20

BLUETOOTH®
Bluetooth mode settings
1 Press and hold .
2 Press to select an item (see the following table), then press
3 Repeat step 2 until the desired item is selected/activated or follow the instructions
stated on the selected item.
4 Press to exit.
To return to the previous setting item, press
BT MODE
PHONE SELECT *
Selects the phone or audio device to connect or disconnect.
" " appears in front of the device name when connected.
AUDIO SELECT *
" " appears in front of the current playback audio device.
DEVICE DELETE 1 Press
2 Press
PIN CODE EDIT Changes the PIN code (up to 6 digits).
(0000) 1 Press
2 Press
Repeat steps
3 Press
RECONNECT ON: The unit automatically reconnect when the last connected Bluetooth device is within range. ;
OFF: Cancels.
AUTO PAIRING ON: The unit automatically pair supported Bluetooth device (iPhone/iPod touch/Android device)
when it is connected through USB input terminal. Depending on the operating system of the
connected device, this function may not work. ; OFF: Cancels.
INITIALIZE YES: Initializes all the Bluetooth settings (including stored pairing, phonebook, and etc.). ;
NO: Cancels.
INFORMATION MY BT NAME: Displays the unit name ("KD-R8
unit.
* You can only connect a maximum of two Bluetooth phones and one Bluetooth audio device at any time.
16
ENGLISH
.
to select a device to delete, then press
to select [YES] or [NO], then press
to select a number.
to move the entry position.
1 2
and until you finish entering the PIN code.
to confirm.
BT"). ; MY ADDRESS: Shows address of this
Bluetooth compatibility check mode
You can check the connectivity of the supported
. profile between the Bluetooth device and the unit.
• Make sure there is no Bluetooth device paired.
1
Press and hold
"BLUETOOTH"
"SEARCH NOW USING PHONE"
scrolls on the display.
2
Default: XX Search and select "KD-R8
device within 3 minutes.
3
Perform (A), (B) or (C) depending on what
appears on the display.
(A) "PAIRING"
Ensure that the same passkey appears on the
unit and Bluetooth device, then operate the
.
Bluetooth device to confirm the passkey.
.
(B) "PAIRING"
the Bluetooth device.
(C) "PAIRING": Operate the Bluetooth device to
confirm pairing.
After pairing is successful, "PAIRING OK"
Name]" appears and Bluetooth compatibility check
starts.
If "CONNECT NOW USING PHONE" appears, operate
the Bluetooth device to allow phonebook access to
continue.
"TESTING" flashes on the display.
.
"CHECK MODE" appears.
"PIN IS 0000"
BT" on the Bluetooth
"XXXXXX" (6-digit passkey):
"PIN IS 0000": Enter "0000" on
"[Device