Klarstein SKYSCRAPER ICE Mode D'emploi page 20

EN
20
ON/SPEED & After the tank is filled with water, connect the tower
OFF evaporative cooler to a power outlet. The unit will beep twice,
indicating that the cooler is in standby mode at this time. Press
the ON/SPEED button to turn on the tower evaporative cooler.
To adjust the fan speed, press the ON/SPEED button again
until your desired speed has been reached. To turn the tower
evaporative cooler off and revert back to standby mode, press
the OFF button.
COOLER/ After the desired fan speed has been selected, press the
HUMIDIFYER COOLER/HUMIDIFIER button to activate the cooling/
humidifying function. This powers the water pump, cools
the air and adds moisture to your air at the same time. The
snowflake icon will also be visible on the display panel once
the cooling/humidifying function has been selected.
MODE Setting the airflow mode is optional. To set the airflow mode,
press the MODE button.
• Manual Mode: Indicated by the three circular icons on
• Sleep Mode: Indicated by the moon icon on the display
• Natural Mode – Indicated by the palm tree icon on the
TIMER This tower evaporative cooler is equipped with a 7.5 hour
programmable timer. To set the timer, press the TIMER button.
Each press of this button will add 0.5 hours to the set time. The
set time will be indicated in the middle of the display panel.
SWING To activate the oscillation feature, press the SWING button.
The evaporative cooler's air louvers will automatically move
from side to side, which increases air circulation and distributes
air more evenly.
the display panel, this allows you to set the fan speeds
manually.
panel, this setting will gradually lower the fan speed
at different intervals. If the fan speed is set to high, the
cooler will run for 30 minutes on high speed, 30 minutes
on medium speed and then continue to operate on low
speed.
display panel, this setting will adjust the airflow speed
between low, medium and high.