Thermador PROFESSIONAL PRO HARMONY PRG304GH Manuel D'installation page 10

Installation Clearances with Flush Island Trim
36" (914 mm) min .
to combustible
materials
36¾" (933 mm) Max.
35⅞" (911 mm) Min.
as defined in the "National Fuel Gas Code" (ANSI Z223.1, Current Edition).
Clearances from non-combustible materials are not part of the ANSI Z21.1
scope and are not certified by CSA. Clearances of less than 12" (305 mm)
must be approved by the local codes and/or by the local authority having jurisdiction.
28" (711 mm)
27¼" (692 mm)
24⅝" (625 mm)
24" (610 mm)
max. recess depth
24¾" (629 mm)
23" (584 mm)
44⅞" (1140 mm)
Total Clearance
12" (305 mm) min. to 12" (305 mm) min. to 12" (305 mm) min. to
combustible surface combustible surface combustible surface
with Flush Island Trim with Flush Island Trim with Flush Island Trim
Cantilever
If an inner wall
is used under
the cantilever counter
top, there should be a
⅛" (3 mm) gap from
the rear of the range
to the inner wall.
Figure 3: Installation Clearances with a Flush Island Trim
Combustible
Materials
Shaded area behind Shaded area behind Shaded area behind
range indicates range indicates range indicates
minimum clearance minimum clearance minimum clearance
to combustible surfaces, to combustible surfaces, to combustible surfaces,
combustible materials combustible materials combustible materials
cannot be located within cannot be located within cannot be located within
this area. this area. this area.
For Flush Island For Flush Island For Flush Island
Trim installations, Trim installations, Trim installations,
counter surface should counter surface should counter surface should
have a cantilever edge have a cantilever edge have a cantilever edge
meeting the back meeting the back meeting the back
section of the Flush section of the Flush section of the Flush
Island Trim accessory. Island Trim accessory. Island Trim accessory.
English 7