Resetting The Main Unit - Pioneer VSX-516 Mode D'emploi

10 Additional information
Problem
No sound from surround back
speakers.
No sound from subwoofer.
Noise during playback of a
cassette deck.
No sound is output or a noise
is output when software with
DTS is played back.
During a playback search,
noise is output from a DTS
compatible CD player.
Can't operate the remote
control.
The display is dark or off.

Resetting the main unit

Use this procedure to reset all the receiver's
settings to the factory default. Use the front
panel controls to do this.
1 Switch the receiver into standby.
2 While holding down the TONE button,
press and hold the
about three seconds.
36
En
Remedy
• Refer to Speaker setting on page 28 to check the surround back
speaker settings.
• Refer to Channel level on page 28 to check the speaker levels.
• Refer to Using surround back channel processing on page 24 to
make sure surround back channel processing and the sound mode
are set for surround back sound.
• Make sure the subwoofer is switched on.
• If the subwoofer has a volume knob, make sure it's turned up.
• The Dolby Digital or DTS source you are listening to may not have
an LFE channel.
• Switch the subwoofer setting in Speaker setting on page 28 to YES
or PLUS.
• Switch the LFE Attenuator Setup on page 30 to
LFEATT 10
.
• Move the cassette deck further from your receiver, until the noise
disappears.
• Set the digital volume level of the player to full, or to the neutral
position.
• This is not a malfunction, but be sure to turn the volume down to
prevent the output of loud noise from your speakers.
• Replace the batteries (refer to page 5).
• Operate within 23 ft. (7 m), 30° of the remote sensor on the front
panel (refer to page 5).
• Remove the obstacle or operate from another position.
• Avoid exposing the remote sensor on the front panel to direct light.
• Press DIMMER on the remote repeatedly to return to the default.
STANDBY/ON button for
3 When you see RESET? appear in the
display, press the ENTER button.
OK? shows in the display.
4 Press SETUP to confirm.
OK appears in the display to indicate that the
receiver has been reset to the factory default
settings.
LFEATT 0
or