skilsaw SPT84 Consignes D'utilisation/De Sécurité page 5

Do not stand on tool. Serious injury may occur if
the tool is tipped or if the cutting tool is acciden-
tally contacted. Do not store materials on or near
the tool such that it is necessary to stand on the
tool to reach them .
The operation of any
power tool can result
in foreign objects
being thrown into the
eyes, which can result
in severe eye damage.
Always wear safety
goggles that comply
with ANSI Z87 .1 before commencing power tool
operation .
POWER TOOL USE AND CARE
Do not force the power tool. Use the correct
power tool for your application. The correct
power tool will do the job better and safer at the
rate for which it was designed.
Do not use the power tool if the switch does
not turn it on and off. Any power tool that can-
not be controlled with the switch is dangerous
and must be repaired.
Disconnect the plug from the power source
and/or remove the battery pack, if detachable,
from the power tool before making any adjust-
ments, changing accessories, or storing
power tools. Such preventive safety measures
reduce the risk of starting the power tool acciden-
tally .
Store idle power tools out of the reach of chil-
dren and do not allow persons unfamiliar with
the power tool or these instructions to oper-
ate the power tool. Power tools are dangerous
in the hands of untrained users.
General Power Tool Safety Warnings
SAVE THESE INSTRUCTIONS
Maintain power tools and accessories. Check for
misalignment or binding of moving parts,
breakage of parts and any other condition
that may affect the power tool's operation. If
damaged, have the power tool repaired before
use. Many accidents are caused by poorly main-
tained power tools.
Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges
are less likely to bind and are easier to control.
Use the power tool, accessories and tool bits
etc. in accordance with these instructions,
taking into account the working conditions
and the work to be performed. Use of the
power tool for operations different from those in-
tended could result in a hazardous situation.
Keep handles and grasping surfaces dry,
clean and free from oil and grease. Slippery
handles and grasping surfaces do not allow for
safe handling and control of the tool in unex-
pected situations.
Use clamps or other practical way to secure
and support the workpiece to a stable plat-
form. Holding the work by hand or against your
body is unstable. It allows for work to shift, causes
binding of the tool and loss of control.
Do not alter or misuse tool. Any alteration or
modification is a misuse and may result in serious
personal injury.
Have your power tool serviced by a qualified
repair person using only identical replace-
ment parts. This will ensure that the safety of the
power tool is maintained.
When servicing a tool follow instructions in
the Maintenance section of this manual. Fail-
ure to follow Maintenance Instructions may cre-
ate a hazard.
-5-
SERVICE