Troubleshooting - skilsaw SPT84 Consignes D'utilisation/De Sécurité

Problem Cause
1 . Power cord is not plugged in.
2. Fuse or circuit breaker tripped.
Tool will not
3. Cord damaged.
start .
4. Burned out switch.
1. Extension cord is too light or too long.
Wheel does
not come up 2 . Low house voltage .
to speed.
1 . Abrasive wheel is out of balance .
2. Saw is not mounted securely to stand
Excessive or workbench .
vibration .
3 . Abrasive wheel bolt is not tight .

Troubleshooting

-22-
Remedy
1. Connect the power cord to an
electrical outlet .
2. Replace fuse or reset tripped cir-
cuit breaker .
3. Have cord replaced by an Autho-
rized SKILSAW Service Center or
Service Station .
4. Have switch replaced by an Au-
thorized SKILSAW Service Cen-
ter or Service Station .
1. Replace with adequate cord.
2 . Contact your electric company .
1 . Replace wheel .
2. Tighten all mounting hardware.
3. See "Abrasive Wheel Removal
and Installation" section in this
manual .