skilsaw SPT84 Consignes D'utilisation/De Sécurité page 21

MOTOR BRUSH INSPECTION
/REPLACEMENT
To Inspect or Replace Brushes:
1 . Unplug the saw .
2 . Remove the brush cap on the motor using a
wide flat blade screwdriver.
NOTE: The brush cap is spring loaded by the
brush assembly .
3. Pull out the brush (Fig. 12). Repeat for the
opposite side.
NOTE: If reinstalling the existing brush or
brushes, make sure the brush goes in the
same way it came out . Otherwise a break-in
period will occur that will reduce motor perfor-
mance and increase brush wear.
4 . Install new brush . The two tabs on the brush
terminal go in the same hole the carbon part
fits into.
5. Tighten the brush cap but do not overtighten.
Maintenance
FIG. 12
Brush
Terminal
Brush Cap
-21-
Brush