Electrical Connections (Stacked Ovens) - ITW Food Equipment Group HOBART VC4ED Manuel D'installation Et D'utilisation

ELECTRICAL CONNECTIONS (Stacked Ovens)

ELECTRICAL AND GROUNDING CONNECTIONS MUST COMPLY WITH THE APPLI
CABLE PORTIONS OF THE NATIONAL ELECTRICAL CODE AND/OR OTHER LOCAL ELECTRICAL
CODES.
DISCONNECT ELECTRICAL POWER SUPPLY AND PLACE A TAG AT THE
DISCONNECT SWITCH TO INDICATE THAT YOU ARE WORKING ON THE CIRCUIT.
Make sure that the electrical power supply agrees with the speci ications on the oven data plate, the wiring
diagram on the oven and Electrical Data, page 5.
Wires to connect both ovens are provided with
Carefully route these leads from the top oven through the bushing (supplied with
stacking kit) through the electrical access knockout holes common to both ovens.
Connect wires X, Y and Z from the upper oven to the lower oven per the wiring diagram. Attach the
power supply conduit to the bottom of the lower oven. Connect the power supply leads to the line
side of the terminal block on the bottom oven.
Finally, inspect and check all wiring and terminal connections for tightness or pinch points (cover on
oven frame).
Refer to reference drawing 426986 supplied with the stacking kit for electrical connection instructions.
Refer to instructions supplied with the stacking kit for marking the combined electrical load information
to the electrical data plate of the bottom oven.
– 7 –
oven .