Assembling The Stand To The Oven; Electrical Connections; Electrical Data - ITW Food Equipment Group HOBART VC4ED Manuel D'installation Et D'utilisation

ASSEMBLING THE STAND TO THE OVEN

Attach each of the four leg assemblies to the bottom of the
oven with the 24 bolts and lockwashers (six per leg). Carefully
raise the oven to the normal position.
Attach the undershelf to the legs with eight bolts and
lockwashers (two per leg).
Install the rack guides into the shelf at the desired locations
(for pan or ‡at rack), then attach the rack supports to the
top end of the rack guides. Attach rack supports to the leg
assembly by removing one middle bolt and reattaching the
back through the end holes in the rack support (Fig. 2).

ELECTRICAL CONNECTIONS

ELECTRICAL AND GROUNDING CONNECTIONS MUST COMPLY WITH THE APPLI
CABLE PORTIONS OF THE NATIONAL ELECTRICAL CODE ANSI/NFPA70 (LATEST EDITION) AND/OR
OTHER LOCAL ELECTRICAL CODES.
DISCONNECT ELECTRICAL POWER SUPPLY AND PLACE A TAG AT THE
DISCONNECT SWITCH TO INDICATE THAT YOU ARE WORKING ON THE CIRCUIT.
Remove the wiring compartment cover on the front of the oven. Remove the appropriate knockout on the
bottom of the oven and attach the power supply conduit to the bottom of the oven.
Comply with the appropriate wiring diagram (located inside the right side panel) when making connections
to the electrical supply lines.
Replace the wiring compartment cover and right side panel. Turn on the power supply.
TOTAL
KW
L1-L2 L2-L3 L1-L3 L1-L2 L2-L3 L1-L3 L1 L2
Single Oven 12.5
Stacked Oven 25

ELECTRICAL DATA

208-240 V 480 V
3-PHASE LOADING 3-PHASE LOADING
KW PER PHASE KW PER PHASE
4 4 4.5 4 4
8 8 9 8 8
NOMINAL AMPERES PER LINE WIRE
3-PHASE
208 V 240 V
L3 L1 L2
4.5 35 33 35 33 29
9 70 66 70 66 58
– 5 –
BACK
FRONT
Fig. 2
480 V
208 V 240 V 480 V
L3 L1 L2 L3
33 14.4 15.3 15.3 60
66 28.8 30.6 30.6 120
PL-53274
1-PHASE
52 26
104 52