Breville 800BLXL/B Livret D'instructions page 7

OPERATING YOUR BREVILLE DIE-CAST HEMISPHERE BLENDER™
7. At the end of use, always ensure the
Breville Die Cast Hemisphere Blender is
turned off by pressing the 'Power' button
on the control panel. Then unplug the
cord. Ensure the motor and blades have
completely stopped before attempting to
move the appliance, or when the Breville
Die-Cast Hemisphere Blender™ is not in
use and before disassembling, cleaning
and storing.
NOTE:
During the blending process,
ingredients may stick to the sides
of the blender jug. To push the food
back onto the blades, press the
'Power' button on the control panel
and remove the power cord.
Remove the lid and use a plastic
spatula to scrape down the sides
of the jug. Replace the lid before
recommencing blending.
NOTE:
If the blades become stuck, the
blender will automatically turn off.
To reset, turn the blender off at the
power outlet, clean the jug and
blades with a spatula and then turn
back on. The blender will be reset.
If any moisture or liquid appears on top
of the motor base during blending, press
the 'Power' button on the control panel,
and remove the power plug. Remove
the blender jug. Wipe the motor base
immediately with a dry cloth or paper
towelling to absorb the liquid. Check the
blender jug is correctly assembled.
12
NOTE:
The Die-Cast Hemisphere Blender™
features a motor overload protection
feature. If the motor is being
overloaded, the motor will stop and
the key LED's will illuminate and
fl ash. To restart the blender again,
unplug from the mains let it cool
down for 30 minutes or longer.
Dissassembling the blender
1. Always ensure the Breville Die-Cast
Hemisphere Blender™ is switched off
by pressing the 'Power' button on the
control panel. Then unplug the power
cord.
2. Remove the blender jug from the motor
base by grasping the handle and lifting
the jug in an upward direction. Remove
the blade assembly by upturning the
blender jug and twisting the Blade
Removal System clockwise, then lift
upwards and away from the base of
the blender.
OPERATING YOUR BREVILLE DIE-CAST HEMISPHERE BLENDER™
3. Remove the silicon seal from the blade
assembly.
13