Dremel VELOCITY VC60 Consignes De Fonctionnement/Sécurité page 8

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

making any assembly, adjustments or
changing accessories. Such preventive
safety measures reduce the risk of starting the
tool accidentally.
always wear protective gloves. Such
preventive safety measures reduce the risk of
injury from sharp edges of the accessories.
Application tools can become very hot while
working. Danger of burns!
INSTALLING ACCESSORIES WITH QUICK
LOCK™ ACCESSORY CHANGE
The Dremel Velocity™ (Model VC60) includes
an integrated accessory change mechanism.
The Quick Lock™ accessory interface allows
you to install and remove accessories without
the need of a wrench or hex key.
1. To install an accessory using the Quick
Lock™ feature, hold the tool with the Quick
Lock™ lever facing down to prevent the blade
from falling off the accessory holder when
installing and removing accessories.
2. Turn the Quick Lock™ lever on the side of
the tool to unlock the clamping mechanism
(Fig 2). Push the lever until it stops. The lever
needs to be fully engaged to unlock the
clamping mechanism.
3. Clean accessory holder, accessory and the
clamping flange with a clean cloth.
4. Place the accessory onto the accessory
holder making sure the accessory engages
all pins in the holder and the accessory is
flush against the accessory holder (Fig. 3a &
Fig 3b).
Disconnect the plug from
the power source before
For all work or when
changing accessories
UNLOCK
LOCK
Assembly
CLAMPING
FLANGE
FIG. 3b
when fastening accessory. Avoid placing
hands or fingers between lever and tool
body.
5. Turn the Quick Lock™ lever on the side of
the tool to the locked position, to securely lock
the accessory in place (Fig. 2).
NOTE: Some accessories, such as scrapers or
blades, may be mounted either straight on the
tool, or at an angle to increase usability (Fig. 4).
FIG. 2
In order to do this with the Quick Lock™
interface, place the accessory onto the
accessory holder making sure the accessory
engages all pins in the holder and the accessory
is flush against the accessory holder. Securely
lock the accessory in place as described
previously (Fig. 2).
-8-
ACCESSORY
HOLDER
CLAMPING
FLANGE
To avoid pinching, firmly
hold Quick Lock lever
FIG. 3a
ACCESSORY
ACCESSORY
ACCESSORY
HOLDER
FIG. 4

Publicité

Table des Matières
loading

Table des Matières