Operating The Keys; Switching On The Hob And Cooking Zones; Switching Off A Cooking Zone; Switching Off The Hob - FORS HCN 6042 ES Mode D'emploi Et Instructions De Montage

lits
28
Operation
Stand-by dot

4.3 Operating the keys

The controls described here expect the pressing of a
(selection) key to be followed by the pressing of a subse-
quent key.
The next key will need to be pressed within 10 seconds,
otherwise the selection will be deleted.

4.4 Switching on the hob and cooking zones

1. Press the ON/OFF key
power setting 0 appears and a short signal will sound.
The stand-by dots will blink. The controls are ready for
operation.
2. Use the Power setting display (as a key) to select a
cooking zone. The stand-by dot of the cooking zone
selected will light up.
3. The touch control
ately afterwards. A power setting will be switched on.
..........left ............. power setting 0
..........center ........ power setting 5
..........right ........... power setting 9
See the section on Worth knowing about the slider
(sensor fi eld)
Press the respective sensor fi eld
a power setting or to switch on an additional cooking
zone.
Important: the stand-by dot of the cooking zone selec-
ted must light up.
4. Put a cooking pot onto the cooking zone.
4.5 Switching off a cooking zone
5. Use the power setting display (as a key) to select a
cooking zone. The stand-by dot of the cooking zone
selected must light up.
6. a) Press the sensor fi eld on the far left
b) drag your fi nger to the left across the touch control
to reduce the power setting to 0
c) press the ON/OFF key
switched off (all the cooking zones are switched off ).
4.6 Switching off the hob
7. Press the ON/OFF key
switched off , irrespective of any settings.
Please note:
The hob will switch off automatically after 10 seconds
when all the cooking zones are switched of manually (pow-
er setting 0) and no key/sensor fi eld is pressed afterwards.
GB
(approx. 1 sec.) until the
must be activated immedi-
to change
or
. The entire hob will be
. The hob will be completely