I-VALO XENRE XE80 Notice D'utilisation, D'installation Et De Maintenance page 19

These instructions must be kept and handed over to the user of
the property!
The light source may be replaced only by the manufacturer or a person
authorised by the manufacturer. The product contains electronics sensitive
to electrostatic discharge (ESD) and mechanical stress. In order to avoid
damage to the LED chips, avoid touching an uncovered circuit board, such as
the LED module, by hand or with a tool. This must be taken into account during
ESD
maintenance.
INSTALLATION
•
The luminaire may only be installed by a professional electrician in accordance with
local legislation.
•
When connecting the luminaires, it must be ensured that the power cable is not live.
•
In order to avoid damage to the electronic control gear and other sensitive electronics,
connect the neutral and phase conductors before performing the insulation test
(max. 500V DC).
•
Modifying the structure of the luminaire and making additional connections is prohibited.
•
I-Valo luminaires are always delivered with premade installation holes, and no other holes
may be made in the frame.
•
The XENRE luminaire is installed using separately ordered mounting brackets , in
accordance with the installation location:
- installation rail for one luminaire X100
- installation rail for two luminaires X200
- wall bracket X110
NB! The fastening screws of the X brackets are preinstalled in the luminaire frame.
Maximum allowed tightening torque 5.9 Nm. The I-Valo basic brackets listed below also
require an X100 or X200 bracket.
- chain suspension 6020
- wire bracket 6079
- wall bracket 6060 (pair)
I-VALO OY | TEL +358 (0) 10 501 3000 | INFO@I-VALO.COM | WWW.I-VALO.COM
EN
19