Dutch originals DO-CH-ACON090 Manuel D'utilisation page 13

Press the mode button on the device
on the digital control panel lights up.
10
You can select the required FAN speed as described in "FAN speed"
Dehumidifying mode
Press the mode button on the device
indicator lights up.
In this mode, the FAN speed cannot be selected and will be in the default low speed
setting.
Note!
In dehumidifying mode, the drain hose
opening to release the condensed water.
8
See "Drainage" for connection instructions.
Smart mode
In the smart mode the cool and FAN mode will be automatically regulated, depending on
the room temperature.
Press the mode button on the device
indicator on the digital control panel lights up.
10
Once the smart mode has been selected, the mode is activated in the default target setting
of 23°C.
At a temperature of ≥ 24°C , the device operates in cool mode.
At a temperature between 22°C and 24°C, the device operates in fan mode.
When you switch from the COOL mode to SMART mode, it operates in the smart mode on
the degrees set in the cool mode. The temperature cannot be adjusted in the smart mode.
Sleep mode
The sleep mode can be activated in cooling mode.
After 1 hour the preset temperature is increased by 1°C, after another hour the preset
temperature will again be increased by 1°C (maximum 2 degrees increase).
Press the mode button on the device
on the digital control panel lights up.
11
Timer setting
The timer settings can be set from 1 hour to 24 hours.
There are 2 timer modes, to turn the device OFF and to turn it ON.
Timer turn OFF (when power is ON)
• Press the TIMER button on the device
indicator on the digital control panel lights up.
11
• To set the timer delay OFF, press the increase
press the increase
or decreases by one hour. The selected time is indicated on the display
Timer turn ON (when power is OFF)
• Press the TIMER button on the device
indicator on the digital control panel lights up.
11
• To set the timer delay OFF, press the increase
B C
or decrease
or remote control
2
or remote control
2
F needs to be connected to the drain
or remote control
2
or remote control
2
or remote control
3
or decrease
7
button on the remote control. Each press increases
or remote control
3
or decrease
7
EN 11
until the FAN LED indicator
E
until the DEHUM LED
E
until the SMART LED
E
until the SLEEP LED indicator
E
until the TIMER LED
D
button on the device or
8
.
9
until the TIMER LED
D
button on the device or
8