Siemens TE60 Série Mode D'emploi page 44

en
The appliance is ready for use again.
F Rinsing the filter simultaneously
activates the setting for displaying the
message "Please change water filter".
When this message appears, or at
the latest after two months, the filter
will no longer be effective. It needs to
be replaced for reasons of hygiene
and to prevent a build-up of limescale
(which could damage the appliance).
If you do not intend to insert a new filter,
select the setting No filter and touch B
to confirm.
If the appliance has not been used
F
for a prolonged period (for example,
while you are on holiday), the existing
filter should be rinsed before the
appliance is used again. To do this,
simply dispense a cup of hot water.
Cleaning and care
Starting the special service programmes.
You can select Rinse the milk system,
Descale, Clean or calc'nClean.
● Use I to choose the desired
programme and touch B to confirm
your choice.
● Touch C to begin running the
programme.
Important: Be sure to take note of
F
the section on "Service programmes".
40
Info Service programmes
(depending on the type of appliance)
Display how many beverages can still be
prepared before it will be necessary to run
one of the service programmes.
● Use I to display Clean after --- c or
Descale after --- c.
● Touch F to exit from the display.
F For technical reasons the counter
does not represent a precise number
of cups.
Frost protection
Service programme to prevent frost
damage during transportation and storage.
This programme completely empties the
appliance.
F The appliance must be ready for use
and the water tank 5 must be filled.
● Touch C to begin running the
programme.
● Remove the water tank; the appliance
automatically empties all its pipes and
then switches itself off.
● Empty the water tank 5 and the drip tray 17.
Key tones
Switches on or off the tones that you hear
when you touch the control panel.
● Touch B to confirm your choice.
● Use I to choose Key tones ON
or Key tones OFF and touch B to
confirm your choice.
Beverage statistics
(depending on the type of appliance)
Shows the volume of drinks dispensed
since the appliance was taken into service.
● Touch F to exit from the display.
Factory settings
Resets your own settings to the condition
when delivered.
● Touch C to clear all your own
settings.