Atlantic Tatou Notice D'utilisation Et D'installation page 11

- This appliance is not intended for use by young children or invalid
persons without supervision.Young children should be supervised to
ansure that they do not play with the appliance, lean against the front
or insert objects or paper in it.
- Do not obstruct the grills, even partially (either on the front of the
appliance or underneath it): otherwise the appliance may overheat.
- If the supply cord is damaged, it must be replaced by a service agentor similarly
qualified person in order to avoid a hazard (applies to units fitted with a supply cord and plug).
- Units fitted with a three core supply cord (brown, blue and black), must be directly connected to hard
wiring by a licensed electrician.
- All work on the interior of the appliance must be carried out by a licensed electrician.
- To maintain the appliance's performance, the upper and lower grills must be cleaned with a vacuum clea-
ner or a brush approximately twice a year.
- Every five years, have the internal components checked by a qualified electrician (cleaning and interfacing).
- In dirty environments, stains may appear on the appliance's grill.This is caused by poor quality ambient air.
Such stains do not justify replacement of the appliance under guarantee.
- The casing can be cleaned with a damp cloth.
Never use any abrasive products.
Problems encountered
The appliance does not heat
The appliance does not follow
the programming instructions
The appliance heats all the time
This appliance is electronically controlled and its microprocessor can be affected by significant local inter-
ferences (outside the EU norms defining the level of protecton against interference).
If a problem should arise (locked thermostat, etc), cut the power supply to the appliance (fuse, circuit brea-
ker, etc) for approx. 10 minutes to reset the appliance.
If the problem recurs frequently, have your electricity supply checked by your electricity supplier.
W
ARNINGS
M
AINTENANCE
T
ROUBLESHOOTING
- Check that the programming unit is in Comfort mode.
- Ensure that the circuit breakers installed are engaged and that the
power cutoff (if fitted) has not cut off the power supply to the applian-
ce.
- Check the air temperature.
- Ensure that the programming unit is being used correctly (refer to
its operating manual) or that the time clock is correctly seated in its
housing and is operating normaly (batteries ?).
- Check that the appliance is not situated in a draught and that the
temperature setting has not been altered.
Checks to be made