1) Description of the control unit
Cursor of the modes
1
Eco temperature set value adjustment
knob (locate from 1 to 8).
Comfort temperature set value adjust-
ment knob (locate from 1 to 8).
V1
Heating light
V2
Eco mode light
V3
Comfort mode light
2) Setting the comfort temperature
This is the temperature desired while the room is occupied.
a) Set cursor
to position
1
b) Adjust knob
to 5.The heating indicator V1 will illuminate if the temperature is below the desired
temperature.
c) Wait a few hours for the temperature to stabilise.
d) When you are happy with the setting (you may wish to use a thermometer to check), mark the posi-
tion once and for all.
If you are not happy with the setting, re-adjust it and proceed again from point c).
3) Setting the Eco temperature
This is the temperature desired when the room is unoccupied.You are advised to use this mode when
the room will be unoccupied for more than 2 hours.
a) Set cursor
to
1
b) Adjust knob
to between 3 and 4.The heating indicator V1 will illuminate if if the ambient temperatu-
re is lower than the instruction of desired temperature ECO.
c) Wait a few hours for the temperature to stabilise.
d) When you are happy with the setting (you may wish to use a thermometer to check), mark the posi-
tion once and for all.
If you are not happy with the setting, re-adjust it and proceed again from point c).
4) Frost protection mode
It is the mode which makes it possible to maintain the temperature with approximately 7°C in the part at
the time of a prolonged absence of the house (generally for more than 24 hours).
Set cursor
to
1
5) Heating indicator V1
This shows when the resistance heating elements are supplying heat. It flashes when the temperature sta-
bilises and goes out when the temperature is too high.
6)Stopping of the appliance
To put the appliance in off position, position the cursor
U
SING THE APPLIANCE
, the light V3 comes on.
, the light V2 comes on.
.
1
V1
V1
V2
V2
on
.
1
V3
V3