Forch Full Torque Mode D'emploi page 66

FULL TORQUE Polishing Maschine
ENG
Permissible grinding body diameter
Grinding body width
Mandrel (with 2 feather keys)
Width × maximum length
Spindle thread / Spindle length
Idle speed (maximum speed)*
Rated power input
Power output
Weight excl. power cable
Supply voltage
Protection class II
Emission values
Vibration emission value (polishing) /
Uncertainty (vibration)
Typical A-weighted sound level
Sound pressure level / Uncertainty
Sound output level / Uncertainty
*High-energy high-frequency interferences may cause speed fluctuations. These fluctua-
tions will level out once the interferences have subsided. The technical data is subject to
tolerances (in accordance with the respectively applicable standards).
Emission values: These value allow the emissions of the electric tool to be
estimated, and compared to other electric tools. Depending on the usage conditions
and the condition of the electric tool or accessory, the actual load may be greater or
smaller. Take into account any work breaks and phases at lower loads in the
estimation. Determine the appropriate protective measures for the user according to the
adjusted estimates, e.g. organisational measures. The vibration total value (vector sum in
three directions) has been determined in accordance with EN 60745. Subject to change in
accordance with technical advances. Measured values in accordance with EN 60745.
Technical data
D
B1
W × L
M / l
n
P1
P2
m
V
A , / K ,
h P h P
L / K
pA pA
L / L
WA WA
100 – 115 mm
50 – 150 mm
19 × 50 – 100 mm
M 14 / 20 mm
820 – 3,000 min -1 (rpm)
1,750 W
1,070 W
2.8 kg
220 – 240 V
Yes
2
< 3.8 / 1.5 m/s
91 / 3 dB (A)
102 / 3 dB (A)