Fulgor Milano M6RT601 Serie Mode D'emploi page 12

are switched-ON at the same time. If
only the inner heating circuits should be
used, the outer heating circuit can be
switched-OFF by means of the multi-
circuit key or in individual steps.
EN
By operating the multi-circuit key the
respective outer circuit of the assigned
active cooking zone (setting π "0") can
be cutoff anytime. An activated outer
circuit will be indicated by an additional
LED. A renewed operation of the multi-
circuit key will add the outer circuit(s)
at any time, the assigned LED´s glow
again (toggle-function).
If a cooking zone other than the one with
multi-circuit function will be selected,
the multicircuit status will be changed
and all cooking zones will be deselected
(the decimal point extinguishes).
Behaviour of dual-circuit cut-OFF:
If the heating element to be controlled
is a triple-circuit heating element, the
course of action is as follows:
• The first activation of the multi-circuit
key cuts-off the outer heating circuit
and the top LED extinguishes.
• A second activation of the multi-
circuit-key
heating circuit. (also the bottom LED
extinguishes.)
• A third activation adds the middle
heating circuit
activation adds the third heating
circuit as well and the assigned LEDs
glow again.
cuts-off the middle
again. A further
Audible signal (buzzer)
While the control is in operation the
following activities will be signaled by
means of a buzzer:
• normal key activation with a short
sound signal.
• continous operation of keys over a
longer period of time (_10 seconds)
with a longer, intermittend sound
signal.
Timer function (optional)
The timer function is realized in two
versions:
• Stand-alone timer 1..99 min: sound
signal when the time is over (= minute
minder). This function is only available
when the cooktop is not in operation,
i.e. when there is no cooking.
• Cooking zone timer 1..99 min: sound
signal when the time is over, four
cooking zones can be programmed
independently.
Timer as minute minder (stand-
alone):
• If the control is OFF the standalone-
timer can be operated byactivating
the timer key. Thetimer display shows
"00".
Operation of the Power-key putsthe
control back into the stand-by mode
and the standalone-timer will be cut-
off.
- Time changes can be made with
1-minute increases using the clock
key from 0 to 99 and the MINUS key
from 99 to 0.
- Continuous operation of the clock
key or MINUS produces a dynamic
12