Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
stands for the heat-up boost) appears
on the display, in alternation with the
chosen setting.
- If a lower setting will be selected
with the MINUS-key after the "A" has
EN
appeared in the display, the automatic
heat-up function will be interrupted.
- By means of the PLUS-key a higher
continious setting can be chosen,
here the duration of the heat-up boost
will be automatically adapted to the
actual selected setting.
- When the heat-up time is over, the
selected (continious) setting will be
indicated on the display.
Residual heat indicator
It is meant to indicate to the user that
the glass ceramic has a dangerous
touch temperature in the circumference
of a cooking zone. The temperature will
be determined following a mathematical
model and the remaining residual heat
will be indicated by means of "H" on
the corresponding 7-segmentdisplay.
Heating-up and cooling down will be
calculated dependent on
• the selected setting ("0" to "9")
• the ON/OFF time of the relays After
switching-OFF the cooking zone the
respective display shows "H" until the
assigned cooking zone temperature is
mathematically in a uncritical level. (≤
60°C).
Automatic
power
(operating time limitation)
Dependent on the selected setting,
every cooking zone will be switched-
OFF after a defined maximum operation
OFF
function
10
time if no operation of the assigned
cooking zone follows within this time
period.
Every change of the cooking zone
condition (by means of the PLUS-
, MINUS- or dualcircuit key for the
respective cooking zone) puts back
the maximum operation time of this
cooking zone to the initial value of the
operating time limitation.
The
maximum
dependent on the selected cooking
zone is defined in enclosure 1.14
Protection
against
switching-ON
• If the electronic control realizes a
continuous operation of keys for
approx. 10 seconds, it switches OFF
automatically. The control sends
out an audible failure signal for 10
seconds, so that the user can remove
the object which has been mistakingly
placed onto the operation surface.
The displays show the failure code "
E R 0 3 ".
• If the failure carries on for more than
10 seconds, only the code " E R 0 3 "
will be displayed as long as the failure
will be recognized by the electronic
control. If the cooking zone is in the
"hot" status, "H" will appear on the
display in alteration with the failure
notice.
• If no cooking zone will be activated
within 20 seconds after switching-
ON by means of the Power-key, the
control switches back from the ON-
condition into the stand-by-mode.
(also see paragraph 1.2)
operation
time
unintended
Publicité
Table des Matières
